A custom air-cylinder driven FCT jig with multi-point test probes, built for rapid PCBA functional verification in workshop and production testing.

This open-frame pneumatic fixture uses a vertical cylinder to lower a multi-probe head onto the loaded PCBA. The probe head carries a row of spring probes that contact several points at once, and air lines with regulator fittings run along the side of the black base. Front push buttons marked for start, clamp, lift and release control the cylinder cycle, and a red power switch sits at the edge. The open frame leaves probes and wiring accessible for adjustment, suiting boards that need fast, repeatable probe contact during production verification.
Key Features
- Air cylinder-driven multi-probe head lowering
- Row of spring probes for multi-point simultaneous contact
- Front buttons for start, clamp, lift and release actions
- Side-mounted air regulator and pneumatic fittings
- Open frame for probe wiring and maintenance access
- Custom probe layout for rapid PCBA verification
Applications
- Rapid functional verification of PCBA in production workshops
- Boards requiring multi-point probe contact in each cycle
- Mid-volume testing with available compressed air
- Stations needing accessible probe adjustment for different runs
FAQ
Q: How is the cylinder cycle controlled?
Front push buttons trigger clamp, lift and release actions; the regulator sets air pressure and pressing force.
Q: Can probes be replaced after wear?
Yes, individual spring probes can be replaced in the probe plate without rebuilding the whole fixture.
Q: What is the difference from the multi-probe tester with touch panel?
This model uses button controls and an open frame, while the touch-panel version has an integrated display and enclosed control base.