Tower-Light Pneumatic FCT Test Fixture for Automated PCBA Inspection

This air-driven functional test fixture uses a tri-color signal tower and safety guard to run fast pass/fail checks on assembled PCBs on electronics production lines.

Front view of a centered pneumatic FCT functional test fixture, with two identical units partially visible on both sides; features tri-color warning light, transparent safety enclosure, pneumatic regulator assembly, E-stop and reset buttons, with Reset and Up controls on the base.
Row of pneumatic FCT functional test fixtures lined up on a factory floor, each equipped with a tri-color tower light, transparent safety guard, emergency stop button and pneumatic pressure regulator.
Close-up front view of a single pneumatic FCT test fixture, showing the tri-color signal tower light, clear safety barrier, internal probe test jig, red E-stop button and yellow power switch, with a pinch-hazard warning label on the housing.

Built for high-volume assembly environments, this pneumatic FCT fixture presses spring probes onto the PCBA automatically after the operator loads the board. The red-yellow-green tower lamp clearly shows running, pass, fail and alarm status at a distance, while the transparent shield blocks accidental hand entry during the test cycle. An emergency stop and reset button are mounted on the front panel for safe daily operation. The probe layout, fixture base and locating pins are customized to match the target board outline and test points.

Key Features

  • Pneumatic cylinder-driven pressing action for consistent probe contact
  • Tri-color signal tower for instant pass/fail/alarm status feedback
  • Transparent safety guard with yellow support columns for operator protection
  • Front-panel E-stop, reset and power switch for safe machine control
  • Custom probe layout and board locating pins tailored to specific PCBA
  • Benchtop frame design suitable for line-side or workstation placement

Applications

  • Mass production PCBA functional testing on SMT and assembly lines
  • Consumer electronics mainboard and power board QC inspection
  • Workstation-side functional verification for mid-volume electronic assemblies
  • Automated pass/fail screening where visual status indication is required

FAQ

Q: Can this fixture be adapted to different PCB sizes?
Yes. The locating pins, probe plate and base are redesigned for each target board; only the pneumatic frame and control layout stay consistent.

Q: What does the signal tower indicate during operation?
The green lamp marks a passed test, red marks a failed unit or fault, and amber signals a running cycle or standby state.

Q: Is safety protection included by default?
A transparent guard, emergency stop button and protective side columns are standard; light curtains or dual-hand start can be added for higher-risk designs.

Scroll to Top